Loading... Please wait...

GlueLogix I/O Box for FEIG RFID

  • Image 1
  • Image 2
Calculated at checkout

Product Description

Triggered Serial communications and 24V I/O for FEIG RFID readers.

Each box is set up to customer specifications and tested at GlueLogix before shipment.  Installation is DIY by customer.


  • DC In: 9-36 VDC, either polarity, on 2.1mm barrel connector
  • DC Out: Input voltage can be shorted to the I/O connector or a power supply can be installed for secondary voltage output like 5V 2.5mm for midrange FEIG readers
  • 0V Out
  • OptoIsolated Trigger In
  • OptoIsolated OK, NG, MARK out
  • RS232 DTE DB9P to RFID Reader
  • RS232 DCE DB9S to PC or PLC

NO PC SOFTWARE NECESSARY!  Boxes are shipped set up and can be plugged in and used without using the DCE connection.  OR the DCE connection can be used to capture RFID chip data to terminal emulation/logging software on the PC.


  • Wait for a trigger
  • Try to read by sending a preconfigured serial command through the DTE connection.
  • Evaluate the serial reply: retry up to 4 times on bad status.
  • Set OK or NG status
  • Save NG status, set Mark output on the next trigger
  • Send chip ID (HF UID or UHF EPC+TID) through the DCE connection.  Host system can use or ignore the chip data.

Default serial is 115200/8N1.  Other baud/parity combinations can be configured at any time.

Case is Serpac A27: 5.31 x 3.35 x 1.50 inch, with 3D printed end plates.

Find Similar Products by Category

Write your own product review

Product Reviews

This product hasn't received any reviews yet. Be the first to review this product!

Add to Wish List

Click the button below to add the GlueLogix I/O Box for FEIG RFID to your wish list.

You Recently Viewed...