Loading... Please wait...

Case and Serial Board for Feig HF RFID Module

  • Image 1
  • Image 2
Calculated at checkout

Product Description

Serial communications, power and SMA antenna interfaces for Feig HF RFID modules in a compact case.

Antenna connection: SMA Female to EXTERNAL antenna

Communication connection: DB9S, DCE (TX pin 2, RX pin 3, COM pin 5).  Tested with Digi Edgeport, Prolific and FT232 USB-Serial adapters.

Power: 9-24V AC or DC.  DC can be + or - tip.  Power jack is 2.1 mm post.  Power can optionally be fed on pins 7 and 9 of the DB9 connector, compatible with Feig MR102.

Dimensions: See Case Drawing

Software: Feig demo software and common USB-serial drivers on CD.

Supports Feig Models (not included)

  • Feig CPR.40 module for ISO14443-A, -B, including all NTAG and Mifare chips
  • Feig CPR.M02 module for ISO15693 and ISO14443-A chips, including all NTAG chips, Mifare Ultralight and Classic
  • Feig ISC.M02 module for ISO18000-3 Mode 3, aka. HF Gen2

Associated products:

  • FEIG MODLE NOT INCLUDED, see Feig Bare Modules
  • GlueLogix assembly and test with purchased module: purchase one hour Design Time with case and module. See Design Time

You may also need:

  • SMA Antenna cable
  • Power Supply, 9-24VDC, 2.1mm post
  • Serial Cable, DB9P
  • USB-Serial adapter

These items are standard and easy to find, but are NOT included with the purchase of SKU FeigA21.  Please contact GlueLogix if you have trouble locating these generic components.

Find Similar Products by Category

Write your own product review

Product Reviews

This product hasn't received any reviews yet. Be the first to review this product!

Add to Wish List

Click the button below to add the Case and Serial Board for Feig HF RFID Module to your wish list.

You Recently Viewed...